#FORTICLIENT WINDOWS 10 ISSUES HOW TO#
#FORTICLIENT WINDOWS 10 ISSUES SOFTWARE#
#FORTICLIENT WINDOWS 10 ISSUES PASSWORD#

Additional comments on the FortiClient v6.2 So if therefore a SSLVPN connection is stopping after straight 8 hours, even though you are using the tunnel continuously, itвЂ™s very likely that you are hitting the authentication timeout. By default this is set to 8 hours (28800 seconds). The auth-timeout is closing the SSLVPN connection based on the the authentication timeout. This configuration can be changed in the WebUI (SSL VPN settings) as well.

The idle-timeout is closing the SSLVPN if the connection is idle for more than 5 minutes (300 seconds). If the SSLVPN connection is established, but the connection stops after some time, you should double-check the following two timeout values on the FortiGate configuration: (once the negotiation is done or stopped you can disable the debugger) (now try to establish the SSLVPN connection) The CLI real-time debugger allows monitoring of the SSLVPN negotiation: вЂ“ The Host could not be contacted (no answer to the TCP SYN packet) General debugging of the SSLVPN negotiation Other error messages В«Unable to establish the VPN connection.

#FORTICLIENT WINDOWS 10 ISSUES SOFTWARE#

This can probably be solved by reinstalling the FortiClient software on the computer. 98% вЂ“ hopefully you are not getting stuck at this pointвЂ¦ this problem is most likely caused by a corrupted FortiClient installation and/or OS problems.Please doublecheck that you are addressing the correct Realm. Another reason for a failure at 80% is that you are not using the correct Realm. If you are using a remote server you can troubleshoot this communication with the following KB articles: Radius and LDAP. Please check user/usergroup/portal and firewall policy configuration on the FortiGate.

#FORTICLIENT WINDOWS 10 ISSUES PASSWORD#

80% вЂ“ at this stage the username and password is verified.

#FORTICLIENT WINDOWS 10 ISSUES HOW TO#

And this KB article explains how to check the TLS versions on a windows client. This KB article describes how to check the TLS versions for SSLVPN on the FortiGate. If the client is using CRL or OCSP make sure that the FortiGate certificate can be checked against those protocols.ДЄdditionally, it is possible that the TLS versions of Client and FortiGate are not matching. Make sure that this popup window is not hidden behind other windows. In this case the user is shown a popup window to confirm the validity of the certificate. If you are using the default FortiGate certificate, the client is probably not trusting this certificate.

40% вЂ“ there is an issue with the certificates or the TLS negotiation.

Check, if the TLS version thatвЂ™s in use by the FortiGate is enabled on your client.

If this message is shown, there is a mismatch in the TLS version.

31% вЂ“ this percentage is also shown as Error -5029.

Double-check that the FortiClient configuration has set the correct IP and port of the Fortigate. Verify that the client is connected to the internet and can reach the FortiGate.

10% вЂ“ there is an issue with the network connection to the FortiGate.

If the negotiation of SSLVPN stops at a specific percentage: Nevertheless problems may occur while establishing or using the SSLVPN connection. Configuring SSLVPN with FortiGate and FortiClient is pretty easy.

Forticlient windows 10 issues